Ford Focus ST MK2 3Door or 5Door “ST-GT1” side Stripes NEW DESIGN
x2 Side Stripes (4 Parts) for off side and near side
Exact Panel fit no cutting required for 3 door – PRE-CUT
5 door requires trimming
CONFIRM 3 OR 5 DOOR FROM SELECTION
Hexis Suptac 10 year exterior vinyl
Application squeegee supplied
Quality “Perfect Tear” paper application tape applied
FOR INSTALLATION – DO NOT APPLY DRY
Clean side panels first.
I would lay some measurement points first for height, as these are long pieces, making sure you have the same height throughout.
3 door option is pre-cut and if you have a 5 door, you will have to trim at the doors and rear panel.
Installation video on my YouTube video:
For first side:
Measure height and lay masking tape indicators.
Cut the stripe into the two sections
Spray the panel with soapy water (a few drops of washing up liquid) and side strip section as it comes off the backing tape. Make sure you spray the soapy water all over, do not apply dry.
This give you the opportunity to move around and position. You will have a good 10 mins before it start to get harder to move. This is plenty of time for positioning.
Once in position use a squeegee remove water and bubbles.
Once done leave to dry and adhere and now move to the next panel.
Repeat on the next side.
DO NOT APPLY DRY. And do not drive the car once done. Please leave over night if possible to completely adhered
Just take your time……
Only logged in customers who have purchased this product may leave a review.